kdaproject.blogg.se - 2010 ford edge front license plate bracket

Be sure to center the license plate with your grill.

Position the license plate assembly in the desired location on your front bumper.

Don’t tighten the screws too tightly at this point. Do the same for the left bracket with the other 2 screws and washers.

With the hex key, attach the right bracket to the right rear side of your license plate, using 2 of the 4 included cap screws and 2 of the 4 included stainless steel trim washers.

Tighten each front screw, while ensuring that the horizontal brackets are perpendicular with the slot in the vertical section. Slide the horizontal section of each bracket so it is this distance from the top end of the vertical brackets. Using the included hex key, loosen the front stainless steel button-head cap screw on the left and right brackets.

First, measure the distance from the lower edge of your bumper to where you want the top of your license plate to be.

Installation is extremely easy, and takes about 10 minutes.

Our low profile front license plate bracket comes pre-assembled in two parts – a left side and a right side, as illustrated in the sketches above.These step-by-step instructions are included with the bracket. Remove and Repair License Plate Bracket Holes in Your Bumper!: If you buy your new car off the lot, or you purchase a used car in a state that requires front license plate tags, and your home state doesn't, you'll often find that the dealer or previous owner required that a front license plate bracket be instal. We offer Brackets for All Ford Models from 1985 to Present day. You can be sure you're getting the Correct fitting Genuine Ford License Plate Bracket at OEMFord.parts. Shop OEM Ford License Plate Brackets for all Ford, Lincoln and Mercury vehicles. RT Off-Road® RT26075 License Plate Bracket. Ford Edge License Plate Bracket Customer Reviews. This adds grip for it being braced against the front splitter near the bottom, as well as it prevents any scratching issues from the metal edge of the plate.

It does need to be angled to fit, so to avoid any rubbing issues I put a few layers of electrical tape folded across the top and bottom edges of the license plate.